Manual

To replace the battery:

1. e battery is stored in the upper half of the sensor

housing. To access the battery, release and remove the

upper housing by twisting it clockwise and lifting the

upper housing o of the lower half..

2. Disconnect the battery wire clip. Remove and replace the

used battery with a fresh 9V Alkaline battery. Reconnect

the battery wire clip.

3. To reassemble the sensor housing, thread the antenna wire

through the lower housing, exiting the center hole in the

bottom grid.

4. Mate the two halves squarely, aligning the translucent

dome above the mounting bracket.

5. Turn the upper housing counterclockwise to securely

engage the lower housing.

To clear a weak battery alert condition

1. At the controller, press .

2. On ALERTS, press .

3. On the Alerts screen, press to move to the

LOW WS BATTERY alert. Press .

4. You will be prompted to CLEAR ALERT?

Press to change to YES. Press .

CLEAR ALL

ALERTS

LOW WS BATTERY