Manual

3
Enter
Setup PWR (Hold)
Mode
Cancel
Setup button
Left arrow
USB Cover
(future use)
Cancel button
Up arrow
Power
button
Right arrow
Enter button
LCD Screen
Installation
EVOLUTION® Smart Connect®
Please see the install sheet that came with the Smart Connect
device.
Installing the Remote Batteries
e remote receives power from a 9-volt battery (not included).
To install the battery:
1. Remove the three
(3) screws from the
battery cover on the
back of the remote,
then remove the
battery cover.
2. Snap the battery onto
the battery clip and
place the battery into
the compartment.
3. Reinstall the battery
cover with the three
screws.
Overview
Down arrow
Battery