Manual

5
Set the PIN
1. Press
Mode
PWR(Hold) to turn on
the remote transmitter.
2. Press Setup twice. “SET
PIN” appears on the screen.
3. Press or to set the rst
digit of the PIN number. Press
to move to the next digit.
4. Repeat step 3 to set the other
numbers in the 4-digit PIN.
5. Press Enter to save the PIN.
Powering the Remote
• Press
Mode
PWR(Hold) to turn on the remote.
• Press and hold
Mode
PWR(Hold) about two seconds to turn o.
Turning o the remote does not turn o irrigation
operations in operation.
Automatic Power Down of Transmitter
e remote powers down after ve minutes of button inactivity
to extend battery life.
Set the Number of Stations
To save time using the remote, set the number of stations in the
transmitter to match the number of stations on the
EVOLUTION® Series controller. For example, for a 8-station
controller, set the transmitter to a station maximum of 8.
1. Press Setup once to view
the Max Station screen.
2. Press or to set
the desired maximum station
number.
3. With the desired number
displayed, press Enter.
Start Program “A” or “B” or ”C”
1. In manual station mode, press to go beyond the
highest station. “P- A” (Program A) appears.
Press again for “P- b” (Program B) or again for
“P- C” (Program C).
2. With the desired Program displayed, press Enter for a
sequential station run.
A remotely started program runs continuously.
Enter
Setup PWR (Hold)
Mode
Cancel
SET
PIN
98 14
Enter
Setup PWR (Hold)
Mode
Cancel
SET
MAX
08
At the Remote