Manual

Installation

Cabinet Installation

Use this page as a template to mark the screw location of the EVOLUTION

cabinet.

ere are two mounting options for the EVOLUTION

. e rst option allows you

to mount the cabinet with three screws and the second option allows you to mount the

cabinet with two screws. For safe and reliable operation, select an installation site that

can provide the following conditions:

• For Indoor model controllers - Inside a garage or other structure that will provide

protection from the weather.

• For Outdoor model controllers - Protection from irrigation spray, wind and snow. A

shaded location is recommended.

• Access to a grounded AC power source (within 4' [1.2 m] for indoor models) that

is not controlled by a switch or utilized by a high current load appliance such as a

refrigerator or air conditioner.

• Access to the sprinkler control valve wiring and optional accessory wiring.

Option 1

Step 1 – Unplug the controller panel ribbon cable. Open the front panel about

and detach it from the cabinet by pulling the bottom portion

upwards. Removing it from the cabinet allows you to access the

mounting location.

Step 2 – Mark the mounting screw location

and

Step 3 – Drill 1/8" (3mm) pilot holes at the marked locations.

Step 4 – Secure the cabinet with screws.

Option 2