Replacement Part List

Oil Fired Gas & Diesel • Rev. 4/7/2016

3. Fit black nozzle on the standard wand, or for the dual wand, turn adjustment knob on, and

adjust for required flow rate. For high pressure soap systems, the black nozzle is not needed; use

one of the other wand nozzles.

4. To apply chemical, engage trigger on pressure wand assembly. Turn chemical injector’s nipple

to adjust flow. For the high pressure soap systems, open ball valve and engage trigger.

5. Chemical can now be applied through pressure wand assembly. It will take 5 – 15 seconds for

chemical to travel to spray nozzle. The volume of chemical being used may be adjusted at the

chemical injector.

6. For best results apply chemical from bottom to top, and allow for proper penetration time prior

to rinsing. Do not allow chemical to dry. Rinse from bottom to top and then top to bottom.

WINTER PUMP/ COIL PROTECTION

The following procedure MUST be used when the pressure washing

unit is stored at temperatures below freezing.

1. All water must be drained or blown (via compressed air) from system. Connect a short piece

of male fitted ½” garden type hose on to the female inlet on the pump.

2. Place the open end of the hose into a wide mouthed container of full strength, winter rated,

vehicle windshield washing fluid or Anti-Freeze, RATED FOR MINIMUM -40°C.

3. Connect the pressure wand assembly.

4. Start the engine and engage the trigger on the pressure gun. Operate the system until the fluid

runs the same color as the windshield washing fluid. Your machine is now prepared for storage.

5. Disconnect fluid supply, blow out with compressed air, and cap end.

GENERAL MAINTENANCE

Burner Maintenance

NOTE: Repair of the burner is to be done by authorized and trained burner professionals

only.

The oil filter cartridge should be replaced every year to prevent fuel contamination and plugging

of fuel pump and nozzle of oil burner. The nozzle should also be replaced at least once every

year or twice if used daily and if poor combustion begins to occur. See the included burner

manual for more information on burner.