Instructions / Assembly

8
Attaching the Fan Blades
Attach the fan blades to the blade holder
medallions and blade holders using the screws
and rubber washers provided, tighten screws
securely. (Fig. 17)
Align motor holes to blade holders and secure
with screws provided, tighten screws securely.
(Fig. 17)
1.
2.
WARNING
TO REDUCE THE RISK OF PERSONAL INJURY, DO
NOT BEND THE BLADE HOLDERS WHILE
INSTALLING, BALANCING THE BLADES, OR
CLEANING THE FAN. DO NO INSERT FOREIGN
OBJECTS BETWEEN ROTATING FAN BLADES.
Blade Balancing
Check that all blade and blade holder screws
are secure.
Most fan wobble problems are caused when
blade levels are unequal. Check this level by
selecting a point on the ceiling above the tip of
one of the blades. Measure from a point on the
center of each blade to the point on the ceiling.
Measure this distance as shown in Figure 18.
Rotate the fan until the next blade is positioned
for measurement. Repeat for each blade.
Measurements deviation should be within 1/8˝.
Run the fan for 10 Minutes.
Use the enclosed Blade Balancing Kit if the
blade wobble is still noticeable.
1.
2.
3.
The following procedure should correct most fan
wobble. Check after each step.
Figure 18
Touching Ceiling
Figure 17
Blades
Blade Holders
Blade Holder
Medallions
Screws
Rubber
Washers
Screws