Instructions / Assembly

9
Installing the Light Kit
Remove 1 of 3 screws from the mounting plate
and loosen the other 2 screws. (Do not remove)
Raise and hold the light kit close to the
mounting plate and proceed to do the wire
connections. Connect the white wire
connectors from the light kit and fan, follow
the same procedure with the black wire
connectors. (Fig. 20)
Place the light kit key holes over the 2 screws
previously loosened from the mounting plate,
turn light kit until it locks in place at the narrow
section of the key holes. Secure by tightening
the 2 screws previously loosened and the one
previously removed.
1.
2.
3.
CAUTION
BEFORE STARTING INSTALLATION, DISCON-
NECT THE POWER BY TURNING OFF THE
CIRCUIT BREAKER OR REMOVING THE FUSE
AT FUSE BOX. TURNING POWER OFF USING
THE FAN SWITCH IS NOT SUFFICIENT TO
PREVENT ELECTRIC SHOCK.
Installing the Mounting
Plate
Remove 1 of the 3 screws from the mounting
ring and loosen the other 2 screws. (Do not
remove)
Place the key holes on the mounting plate over
the 2 screws previously loosened from the
mounting ring, turn mounting plate until it
locks in place at the narrow section of the key
holes. Secure by tightening the 2 screws
previously loosened and the one previously
removed. (Fig. 19)
1.
2.
Moounting Plate
Mounting Ring
Screws
Mounting Plate
Light Kit
Screws
Wire Connectors
Figure 20
Figure 19