Instructions / Assembly

5
Slip coupling cover, canopy cover and canopy
onto downrod. Carefully reinstall hanger ball
onto rod being sure that cross pin is in correct
position, set screws are tighten and wires are
not twisted. (Figure 10)
7.
Figure 11
UL Listed Outlet Box
Hanger
Bracket
120V
Wires
Mounting
Screws
(Supplied
with Electrical Box)
Tab
WARNING
THE TAB IN THE RING MUST REST IN THE
GROOVE OF THE HANGER BALL AS FIGURE 12.
FAILURE TO PROPERLY SEAT THE TAB IN THE
GROOVE COULD CAUSE DAMAGE TO WIRING.
Figure 12
Groove
Tab
Figure 10
Pin in Locked
Positioon
Motor Collar
Coupling cover
Set Screw
Tab
Motor Wires
Ball/Downrod
Assembly
Ceiling Canopy
Canopy Cover
Decorative Scroll
Cotter Pin
Hole
Tighten
Screw
Firmly
Clevis Pin
Installing Fan to
the Electrical Box
WARNING
TO REDUCE THE RISK OF FIRE, ELECTRIC
SHOCK OR OTHER PERSONAL INJURY. MOUNT
FAN ONLY TO AN OUTLET BOX OR SUPPORTING
SYSTEM MARKED ACCEPTABLE FOR FAN
SUPPORT AND USE THE MOUNTING SCREWS
PROVIDED WITH THE OUTLET BOX.
Pass the 120-volt supply wires through the
center hole in the hanger bracket as shown in
Figure 11.
Install the hanger bracket on the outlet box
with the screws and washers provided with
your outlet box (Figure 11).
Security tighten the two mounting screws.
Carefully lift the fan assembly up to the hanger
bracket and seat the hanger ball in the hanger
bracket socket. Make sure the tab on the hanger
bracket socket is properly seated in the groove
in the hanger ball (Figure 12). This will help to
balance the ceiling fan.
1.
2.
3.
4.