PRACTICAL USER'S GUIDE FOR THE ANDONG ELECTRIC FIREPLACE YIWU ANDONG ELECTRIC APPLIANCE CO., LTD. NO.139#, JINSAN ROAD, YIWU, ZHEJIANG PROVINCE, P.R.
QUICK REFERENCE GUIDE I. II. III. Prior to installation, please ensure: 1. The rated voltage of your firebox fits the output voltage of your outlet; 2. The light bulbs in your firebox is in good condition. For checking this, please follow the instructions for replacing the light bulbs on section MAINTENANCE. The heater on your fireplace may emit a slight, harmless odor when first used. This odor is a normal condition caused by the initial heating of internal heater parts and will not occur again.
IMPORTANT INSTRUCTIONS WARNING You should read and always follow the important instructions below to reduce the risk of fire, electric shock, and injury to persons. 1. Read all instructions before using this fireplace. 2. This fireplace is hot when in use. To avoid burns, do not let bare skin touch hot surfaces, such as surfaces near the heater outlet or light bulbs. The grill directly in front of the heater outlet becomes hot during heater operation.
27. indoor and household use 28.
INSTALLATION This section provides step-by-step instructions for installation of your fireplace. WARNING The outlet must be 15A/120V. CAUTION Do not remove the four rubber feet at the bottom of the fireplace insert or install the fireplace insert directly on soft surfaces, which may restrict air circulation. Otherwise, it may cause a risk of fire or damage. 1.
OPERATION This section will explain the function of each convenient control. NOTE The heater may emit a slight, harmless odor when first used. This odor is a normal condition caused by initial heating of internal heater parts and will not occur again. Control the Electric Fireplace A.
When any light or brightness is pressed, the brightness of the light will not change. Light bar sub-2 output, each road divided into four kinds of lights: red, yellow, blue and blue green total of 16 lights, boot all the brightest defaul Timing shutdown: the working state, through the remote control timer key to control the timing. Press to one time for 30 minutes(viewing screen will show 0.
twinkle on turns to remind the user the temperature protection has been cancelled. You can push the ON-OFF switch on the control panel or on the remote controller to turn on the machine again. 2. Please turn off the power of the electric fireplace when you will leave.
MAINTENANCE WARNING Disconnect power before attempting any maintenance or cleaning to reduce the risk of fire, electric shock to persons or damage. Light Bulb Replacement Light bulbs need to be replaced when you notice a dark section of the flame or when the clarity and detail of the log exterior disappears. There are two bulbs under the log set. WARNING Allow at least 5 minutes for light bulbs to cool off before touching bulbs to avoid burning of skin. I.
