Instructions / Assembly

QUICK REFERENCE GUIDE
I. Prior to installation, please ensure:
1. The rated voltage of your firebox fits the output voltage of your outlet;
2. The light bulbs in your firebox is in good condition. For checking this, please
follow the instructions for replacing the light bulbs on section MAINTENANCE.
II. The heater on your fireplace may emit a slight, harmless odor when first used. This
odor is a normal condition caused by the initial heating of internal heater parts and
will not occur again.
III. If your heater does not emit heat, please ensure the Heater Switch is on. For further
information, please consult section Operation of the Practical User's Guide.
Marks
NOTE
Procedures and techniques, that are considered important enough to emphasize.
CAUTION
Procedures, which if not carefully followed, will result in damage to the equipment.
WARNING
Procedures, which if not carefully followed, will expose the user to the risk of serious
injury, illness or death.
This heater is for use on 120 volts. The cord has a plug as shown at A in Figure1. An
adapter as shown at C is available for connecting three-blade grounding-type plugs to
two-slot receptacles. The green grounding lug extending from the adapter must be
connected to a permanent ground such as a properly grounded outlet box. The adapter
should not be used if a three-slot grounded receptacle is available.