Instructions / Assembly

INSTALLATION
This section provides step-by-step instructions for installation of your fireplace.
WARNING
The outlet must be 15A/120V.
CAUTION
Do not remove the four rubber feet at the bottom of the fireplace insert or install the
fireplace insert directly on soft surfaces, which may restrict air circulation. Otherwise, it
may cause a risk of fire or damage.
1. Select a suitable location, which is not susceptible to moisture, safe, dust free, away from
high traffic and away from things may catch fire or block openings such as drapes,
furniture, etc.
NOTE
It is a good idea to place your fireplace near an existing outlet, for ease of
electrical hook up.
2. Place the fireplace in the desired location to see how it will look in the room.
3. Place the mantel in the desired location or build a wall construction in the desired location.
CAUTION
Store your fireplace insert in a dry, safe and dustless place when placing the
mantel or building the wall construction.
4. If there's no 15A/120V outlet near the desired location, install a new one near or behind
mantel.
WARNING
Do not attempt to wire you own new outlets or circuits. To reduce the risk of
fire, electric shock or injury to persons, always use a licensed electrician.
5. Make sure the fireplace insert is switched off (refer to operation instruction section).
6. Plug the fireplace into a 15A/120V outlet. Wiring the cord along the corner of wall.
7. Push the fireplace insert into place so that the panel and the finished mantel surround or
wall surface are in the same plane.