Instructions / Assembly

<FIXED FLAME> When any light or brightness is pressed, the brightness of
the light will not change.
<FLAME> Light bar sub-2 output, each road divided into four kinds of lights: red,
yellow, blue and blue green total of 16 lights, boot all the brightest defaul
<Timing>
Timing shutdown: the working state, through the remote control timer key to control
the timing. Press to one time for 30 minutes(viewing screen will show 0.5), the
maximum state is 10 hours, after 10 hours later then press the timer key, back to no
time state. Set the process flashes, no set action, flashing 3 seconds into the timing
countdown, every 6 minutes, the time is reduced by 0.1(viewing screen show), the
countdown to 0, when the buzzer sound, turn off the machine. If the machine is in
timer state,but turn it off You need turn off the fireplace by hand again,then turn on
the machine ,will no have the timer function.
Regular boot:Turn off state, through the remote control timer key to control the timing.
Press to one time for 30 mins(viewing screen will show 0.5), the maximum state is 10
hours, 10 hours later and then press the timer key, back to no timer state. Set the
process flashes, no set action, flashing 3 seconds into the timing count down state,
every 6 minutes, the time is reduced by 0.1(viewing screen show), the count down is 0,
the buzzer sound, open the machine. If the machine is in the regular boot state, open
the machine by hand, turn off regularly.
B. Operation
On the first usage of remote controller, install the batteries first: open the battery box by
sliding its cover along the arrow, install two AAA batteries according to the marks in the
box, and slide the cover to its original position. If no batteries installed or the batteries are
failure, the remote controller will be unusable.
To use the remote controller effectively, point it to the electric fireplace and keep a
distance of 1-5 meters.
There're five buttons marked the same as buttons on the remote controller, each pair of
them perform the same function, choose as you favour.
1. If the temperature inside of the machine become abnormal, the temperature
protection switch will turn on automatically and the heater will be shut down within
2~3 seconds. When the temperature inside of machine return to normal, the
temperature protection switch will release automatically and the four indicators will