User Manual

FPV Racer PDB with OSD BEC for CC3D

Specification:

Size:36 x 36mm

Mounting holes:30.5 x 30.5mm x M3

5v step down regulator -2A

12V step down regulator -2A

70A constant,110A burst

5v/12v switch for CCD board camera

5v/12v

switch for video transmitter

Firmware release: Minop osd 14.01

Connection Diagram:

Firm

ware upload

Download and extract archive: ConfigTool_minOPOSD.zip

This is a standalone application and so doesn't require further installation.

Start the config tool:

date charset

First update character set stored inside MAX7456 chip, be sure the video side is also powered.

1 - Select the right port, in this example COM1

PAGE 1
FPV Racer PDB with OSD BEC for CC3D Specification: Size:36 x 36mm Mounting holes:30.5 x 30.5mm x M3 5v step down regulator -2A 12V step down regulator -2A 70A constant,110A burst 5v/12v switch for CCD board camera 5v/12v switch for video transmitter Firmware release: Minop osd 14.01 Connection Diagram: Firmware upload Download and extract archive: ConfigTool_minOPOSD.zip This is a standalone application and so doesn't require further installation.
PAGE 2
- Go to Options menu and Update Charset... 3 - Select the character set file (Charset_1_3_0.mcm) where you saved it on your hard drive. 4 - Wait until the process is complete, this can take some time. About charset file... Character set contains all characters used by the MAX7456 chip, it should be updated or the OSD display may be wrong with letters or other exotic characters as shown.
PAGE 3
Update firmware 1 - Select the right port, in this example COM1 2 - Go to Options menu and Update Firmware... 3 - Select the firmware file (.hex) where you saved it on your hard drive. See Downloads. 4 - Wait until the process is complete. OSD configuration Video standard Video standard can be PAL or NTSC, select with the software and the MinOPOsd will talk with the video chip to apply the changes. Go to Video Mode menu and select PAL or NTSC according to the camera used.
PAGE 4
Don't forget to select the Save tab button to apply changes.