Installation Guide

*** PLEASE READ ALL INSTRUCTIONS BEFORE SEPERATING METAL FROM PACKAGE ***
** PLEASE HANDLE METAL CAREFULLY & GENTLY WHEN SEPERATING FOR INSTALLATION **
STEP 1
1. Cut 5° angle on bottom side of jamb pieces (for the threshold, approx. ¼”).
2. Measure side door jambs and cut to total length.
3. Cut ½” off of the wide part of the jambs (this leaves ½” tab on the narrow side).
4. Install side jambs (4 nails equally spaced).
5. Cut top jamb to total length.
6. Cut ½” off of each end of the wide part (this leaves ½” tab on the narrow side on each
end).
7. Cut 45° angle on the tabs of the top jamb and install top jamb (3 nails on a 36" kit / 4 on
a 72" kit) equally spaced.
STEP 2
1. Measure side brickmold. ADD 1” to overall measurement.
NOTE: THE TALL SIDE OF THE PROFILE TO THE OUTSIDE
2. Cut brickmold leaving a 1” tab on the outside.
3. Install side pieces, bending 1” tab over the top of the brickmold.
4. Install side mouldings (4 nails equally spaced - both kit types).
5. Measure and cut top piece to full length. (outside to outside/ inside to inside).
6. Cut 45-degree angle on each side of top piece & install (3 nails on 36" kit / 4 nails on a
72" kit) equally spaced.
7. Caulk all inside corners and seams with a quality caulk (use a ¼ inch bead).
More helpful instructions on next page.