SDS

SAFETY DATA SHEET
PRINSCO, INC
SDS DATE: 8/11/15
Page 2 of 4
SECTION 2: HAZARD(S) IDENTIFICATION (continued)
Effects of Acute Over Exposure: None Determined
Effects of Chronic Over Exposure: None Determined
OSHA Permissible Exposure Limit: 5mg/m
3
respirable fraction dust, 15mg/m
3
total dust
SECTION 3: COMPOSITION
PRODUCT CONTENTS
Gold UV PE MB Non-hazardous Polyethylene Copolymer Blend
Black UV PE MB Non-hazardous Polyethylene Copolymer Blend (Carbon Black)
White UV PE MB Non-Hazardous Polyethylene Copolymer Blend
HDPE Polyethylene Copolymers
SECTION 4: FIRST-AID MEASURES
Skin Contact: For hot product, immediately immerse in, or flush the affected area with large amounts of cold water.
Cover with clean cotton sheeting or gauze and get prompt medical attention. Do not remove material from skin.
Eye Contact: Not likely to be an eye hazard in present form.
Inhalation: No specific treatment is necessary since this product is not likely to be hazardous by inhalation. If
exposed to excessive levels of dust, remove to fresh air. Get medical attention if cough or symptoms develop.
Ingestion: Not likely to be ingested in present form.
SECTION 5: FIRE-FIGHTING MEASURES
NFPA/HMIS FLAMMABILITY: 1
FLASH POINT: >600°F
MELT POINT: >205°F
EXTINGUISHING MEDIA: Dry Chemical, Foam, CO
2
, Water Spray
SPECIAL FIRE FIGHTING PROCEDURES: Avoid inhalation of vapors; Use self contained breathing apparatus when
fire-fighting in confined areas.
UNUSUAL FIRE AND EXPLOSION HAZARDS: Treat as a solid that can burn. Generally burns slowly with a low
smoke density and flaming drips. Polyethylene fines can be an explosion hazard when exposed to heat greater than
its flash point.
SECTION 6: ACCIDENTAL RELEASE
Eliminate sources of ignition in vicinity of released material. Use cation, spill may result in slipping or tripping
hazards.
SECTION 7: HANDLING AND STORAGE
Practice reasonable care and caution when handling. Do not store near extreme heat, flame or strong oxidants.
Minimize dust generation and accumulation. Injury or death can result from product falling from a height or
unexpected movement during storage, unloading or handling. Product is not intended to be walked on due to slipping
and tripping hazards.