Installation Guide

Operating Instructions

Checking for leaks

*WARNING: Before using this outdoor fireplace, make sure you have read , understand and

are following all information provided in the “Warnings” section. Failure to follow those

instructions can cause death, serious injury or property damage.

Burner connections

1. Make sure the regulator hose and valve connections are securely fastened to the burner

and the tank.

2. Visually check the connection between the burner/venture tube and orifice.

3. Make sure the burner/venture tube fits over the orifice.

WARNING: Failure to inspect this connection or follow these instruction which can

cause death, serious bodily injury or damage

to property.

4. Please refer to diagrams for proper installation 。

Tank/Gas line connection

1. Make 2-3 oz. of leak detection solution by mixing one part liquid dishwashing soap with

three parts water.

2. Make sure the control knob is in the "OFF” position.

3. Connect LP gas tank per “Installing LP Gas tank” section.

4. Turn LP gas tank valve to “ON”

5. Spoon several drops of solution or use a spray bottle at all connected locations .

a. If any bubbles appear, turn LP gas tank valve “OFF”, reconnect and retest.

b. If you continue to see bubbles after several attempts, turn LP gas tank valve “OFF”

and disconnect LP

Gas tank, per “Disconnecting LP gas tank” section.

c. If no bubbles appear after one minute, turn LP gas tank valve “OFF”, wipe away

solution and proceed.