Installation Guide

Lighting

CAUTION:Keep outdoor gas appliance area clear and free from combustible

material, gasoline and other flammable vapors and liquid.

CAUTION:Do NOT obstruct the flow of combustion and ventilation air.

CAUTION:Check and clean burner/ venturi tubes for insects and insect nests. A clogged

tube can lead to a fire.

CAUTION:Attempting to light the burner with a lid on it may cause an explosion

1. Make sure all labels, packing and protective films have been removed from the outdoor

fireplace.

2. Check for obstructions of airflow to the burner. Spiders, insects and webs can clog the

burner/venturi tube. A clogged burner tube can lead to a fire.

3. Control knob must be in the “OFF” position.

4. Clear small area of lava rocks away from the pilot housing .

5. Connect LP gas tank per “ Installing gas tank” section.

6. Turn LP gas tank valve to “ON”.

8. Manually ignite with match or lighter.

Push in gas control knob & turn counter clockwise to " HIGH" .

9. Afterthe fire pit lights, release control knob. To decrease the flame, turn the control knob

ccounterclockwise to "LOW". To increase the flame, turn the control knob clockwise to

"HIGH".

Note: If burner fails to remain lit, all valves should be closed and a waiting periodof at least 5

minutes should pass before attemping to light.

CAUTION: After lighting - using a fireplace tool and heat-resistant g ves,lo carefully

move the lava rocks back to their proper position, being careful to avoid the flame.

CAUTION: If ignition does not occur in 5 seconds turn burner control knob to “OFF' ,

wait 5 minutes, fan with a newspaper or magazine, and repeat lighting procedure.

Turning Off

1. Turn LP gas tank valve “OFF” .

Turn control knob to the “OFF” position.

Note: A “poof” sound is normal as the last of the LP gas in burned.

3. Disconnect LP gas tank per “Disconnecting LP gas tank” section.