User manual

Testing phone number

You may use the following command to verify the phone number stored in the car alarm system:

TEST TEL #1513



Always enter the complete phone number in international format (including country

code), e.g. +49… for Germany. The text message commands (TEL1, TEL2,

TEL3,…) change only the phone number of the corresponding memory. The

numbers of the other memory are retained.

12.1.3 Changing the Device Name (Name)

If several products are operated at the same time, it is recommended to assign a different name

to each device. This makes it possible to assign alarm messages to the correct device.

To change the name at your device, send the following text message command:

SET NAME <new name> #1513

Example: Renaming the car alarm system to „NEWNAME“:

SET NAME NEWNAME #1513

The confirmation text message looks as follows:

NEWNAME 1.xx

…………………..

…



The device name has a maximum length of 16 characters.

Resetting to factory settings is possible with the following command:

RESET NAME #1513