Instructions / Assembly

Back Assembly

Front Assembly

Note: Side boards have been

machined with an interlocking

ship lap to ensure a tighter t

between boards.

5½” H x 21½” W

Length 21/” , # of pieces in kit

will vary based on board widths.

Note: Posts are identical and

interchangeable.

PAGE 1
Front Assembly Note: Posts are identical and interchangeable. Back Assembly 5½” H x 21½” W Length 213/8” , # of pieces in kit will vary based on board widths. Note: Side boards have been machined with an interlocking ship lap to ensure a tighter fit between boards.
PAGE 2
Assemble the Front Assembly A by laying two 4” X 4” posts and on the ground approximately 41” apart with the recessed cuts facing up. Choose one Top cross board and one Lower cross board with cleat and place them into the recessed areas on the posts. Place the top board in first. The bottom board will fit easily over the lap of the top board. Make the cross boards flush with the edge of the posts and be sure the ship lap between the boards fits snugly together.
PAGE 3
Repeat Step 4. to create the opposite Side Wall of the Table Planter using the remaining Side Boards and the remaining eight 1¾” screws. 6. Finally, lay in the Bed bottom boards resting them on the Front and Back cleat boards. The Bed bottom boards will be positioned evenly throughout the length of the bed. Gaps between the boards of 1/8” - ¼” are normal and provide adequate drainage and air circulation for the Grande Table Planter . 7.