User Manual

All contents copyright 2015, GOLDWING RC Version 2.0, Sep 2015
1.3 Use some fine sandpaper to roughen up the root of control horn where will be glued into
the slot.
1.4 Fill the slot and coat the root of control horn and the bottom of base plate with 30 minute
epoxy, insert the horn into the slot, press it down firmly. Wipe off excessive epoxy with alcohol
wipes. Set aside until cured.
1.5 Use CA glue to connect hinges for rudder.
1.6 Cut the covering from the rudder servo slots from corner to corner and iron down inside
the openings. Connect servo wire extensions to your servos and secure the connections with
the supplied clips. Feed the servo wires into the fuselage. The screw holes for servo
mounting are laser pre-drilled, it is advisable to apply some thin CA to strengthen them, Install
the servos and screw firmly in place.