User Manual

All contents copyright 2015, GOLDWING RC Version 2.0, Sep 2015
3. Wing Assembly
3.1 Locate two wing panels with ailerons, and two set of control horns and base plates.
3.2 Locate the slot for control horn on aileron, remove the covering over the slot with heated
soldering iron or sharp hobby knife, and make sure you do it on the bottom side of the aileron.
Insert control horn into base plate then into the slot, trace the edge of base plate with hobby
knife then remove the underlying covering.
3.3 Use some fine sandpaper to roughen up the root of control horn where will be glued into
the slot.
3.4 Fill the slot and coat the root of control horn and the bottom of base plate with 30 minute
epoxy, insert the horn into the slot, press it down firmly. Wipe off excessive epoxy with
alcohol wipes. Set aside until cured.