User Manual

3.5 The slots for CA hinges are pre-cut. Insert CA hinges half way into the hinge slots on

aileron, apply a drop of thin CA to secure the hinges. Then insert all hinges into slots on the

wing at once, align aileron with the wing, move the aileron up and down a few times to

reach the minimal hinge gap while still allowing full deflection of the aileron. When satisfied,

apply more think CA on both top and bottom sides of each hinges.

3.6 Cut the covering from the aileron servo slots from corner to corner and iron down inside

the openings. Connect servo wire extensions to your servos and secure the connections

with the supplied clips. Feed the servo wires into the wing and out the root. The screw

holes for servo mounting are laser pre-drilled, it is advisable to apply some thin CA to

strengthen them, Install the servos and screw firmly in place.