Instructions / Assembly

Page 10 of 15 Hurricane 1000 User Manual Rev. 2
Wired Timer
Controller (FC-
T)
Setup
The FC-T
wired timer controller allows you to automatically trigger fog output by setting
interval and duration times. LED indicator lights display the machine and controller’s
current state. Rotary knobs set interval time, output, and duration time, while manual and
continuous buttons allow overriding control.
1. Plug in the fog machine to power.
2. Plug in the wired timer controller to the Manual Remote Connector socket on the back of
the fog machine. (See the product Overview.)
3. Allow the Hurricane 1000 three to four minutes to heat up before continuing.
FC-T Wired Timer
Controller Overview
Wired Timer
Controller (FC-
T)
Operation
The FC-T wired timer controller has three modes of operation: timer, continuous, and
manual.
Timer Mode
To trigger the Hurricane 1000 with the timer function, follow the instructions below:
1. Set the desired output level with the OUTPUT knob.
2. Set the INTERVAL and DURATION knobs to the desired positions.
• The INTERVAL knob sets the amount of time in between bursts of fog.
• The DURATION
knob sets the length of time that the fog machine will run
during the burst.
3. Press the <TIMER ON/OFF>
latching button. The LED indicator above the button
will light up. The timer will now run as set by the INTERVAL, DURATION
, and
OUTPUT knobs.
4. Press the <TIMER ON/OFF> button again to turn off the timer.
The <MANUAL> button will override the timer.
Continuous Mode
To trigger the Hurricane 1000 to continuously output fog, follow the instructions below:
1. Set the desired output level with the OUTPUT knob.
2. Press the <CONTINUOUS> latching button. The LED indicator above the button will
light up. The fog machine outputs fog until the <CONTINUOUS>
button is pressed
again.
3. Press the <CONTINUOUS> button again to stop the fog output.
DO NOT run the product in Continuous mode for longer than 15 minutes.
Continuous mode must be followed by an equal amount of time without output (For
example: follow 8 minutes of Continuous operation with 8 minutes of no output).
DO NOT trigger the product to output fog during that time.
• In order for Continuous mode to run uninterrupted, without the Hurricane 1000
stopping to reheat, set the OUTPUT knob no higher than 7. At Output levels
above 7, the fogger will cycle through intermittent bursts of fog during its
reheating program.
• The duration of Continuous fog output is based on the capacity of the tank.
• Fluid consumption will be significantly increased during Continuous mode.
Uninterrupted Continuous
Mode at Output 7