Instructions / Assembly

Page 12 of 15 Hurricane 1000 User Manual Rev. 2
6. GENERAL TROUBLESHOOTING
Symptom Possible Cause Possible Action
No output or short output
Line blockage or air in fluid
line
Make sure there is fluid in the tank
Turn fog machine 45° to flatten out the bubble and allow the
fog fluid to flow properly
Turn off the product for 5 seconds, and then turn it back on.
Repeat as necessary.
Note: After more than 10 attempts, contact Customer
Service.
Incorrect fluid
Clean thoroughly with CHAUVET FCQ. For full instructions,
see Fogger Maintenance. Refill with CHAUVET water-based
fog fluid.
No output or spitting fluid
Incorrect fluid
Clean thoroughly with CHAUVET FCQ. For full instructions,
see Fogger Maintenance. Refill with CHAUVET water-based
fog fluid.
Blocked pipes
Contact Customer Service
Failing part
Contact Customer Service
Fuse keeps blowing
Excessive load on the
circuit
Make sure that the total load does not exceed 80% of the
breaker or fuse nominal current
Short circuit along the
power lines
Check the power lines and power cords
Product does not power up
No energy on power outlet
Check power outlet
Change to another outlet
Loose or damaged power
cord
Check the power cord
Blown fuse
Replace blown fuse with a good one of the same type and
rating
Internal problem
Send product for repair
Product stops pumping/
Loud noise
Low/No Fluid
Refill product with fluid
If you still experience problems after trying the solutions presented here, contact
Chauvet Technical Support. See Contact Us.