Cerwin Vega Mobile Speakers Congratulations for purchasing Cerwin Vega Mobile speakers for your car audio system. You have chosen Cerwin Vega Mobile because you deserve the best! Cerwin Vega Mobile speakers are designed and engineered to reproduce great sound quality for many years of listening enjoyment in your vehicle! We highly recommend that your new speakers be installed by an authorized Cerwin Vega Mobile dealer.
Specifications MODEL TYPE Installation POWER HANDLING H435 3.5" 2-way coaxial speaker set - 150W MAX / 50W RMS POWER HANDLING H440 4" 2-way coaxial speaker set - 200W MAX / 50W RMS POWER HANDLING H452 5.25" 2-way coaxial speaker set - 250W MAX / 50W RMS POWER HANDLING H465 6.5" 2-way coaxial speaker set - 300W MAX / 50W RMS POWER HANDLING H446 4"X6" 2-way coaxial speaker set - 200W MAX / 50W RMS POWER HANDLING H4653 6.
Installation Specifications H4692/H4693/H4694 Rear Deck Mounting There are two primary methods for mounting speakers in the rear deck of a vehicle, top and bottom mounting. Top mounting requires dropping the speakers in through the deck (interior) while bottom mounting secures the speakers from underneath (trunk). Either method requires a good seal around the frame for the best performance. 6.6” 167.63mm 7.717” 196mm 6.417” 163mm 4.922” 125.01mm 5.945” 151mm 0.512” 13mm 0.709” 18mm 10.63” 270mm 9.
Specifications Installation H465 The illustration below shows how to connect one channel of the H4650C component system (H4TAK is similar in connection, but just amplifier input and tweeter output only) Midbass Driver Tweeter H4653 To Amplifier Crossover Programing 4.173” 106mm H4683 5.787” 147mm Each H650C component set comes with a pair of programmable crossovers specifically designed to work with the midrange speaker and tweeter.
Tweeter Installation H435 0.571” 14.5mm When flush or surface mounting tweeters, make sure the desired location can accommodate the hole sizes and depth required. The tweeter can also be surface mounted atop the dash, door, or rear deck. Mount cup using the provided hardware, flush mount illustration shown below. The flush mount bezel requires cutting a 1.75” (45mm) round opening. Be sure there is AT LEAST 1 INCH (25.4mm) behind the panel so the tweeter has adequate clearance.
