Installation Guide



1420 Terry Ave Unit 1601

Seattle, WA 98101

425 405 5505

inlinedesign.us

Installing Stainless Steel Wall Bracket

Round for Flat and Round Tube

Overview

These are instructions for proper installation of a Stainless Steel

Wall Bracket Round for Flat and Round Tube, HBWA.008, into

sheetrock, wood, or drywall surfaces

This bracket comes with a saddle for both ﬂat and round tubing

and a wall bracket screw/hanger bolt

Brackets should be installed with a maximum distance of 4’

Caution:

Wear protective ANSI approved safety glasses, working gloves

and breathing mask at all times

Tools Required

Stud-ﬁnder

Handheld Drill

3/16”-1/4” Drill Bit

13mm Wrench

4mm Hex Wrench

2.5mm Hex Wrench

This document includes hyperlinks and is intended to be viewed as a PDF ﬁle rather than print material

Page of 1 3

HBWA.005 Components:

1: Wall Bracket Screw

2: Wall Flange

3: Small pointed head screw

4: Horizontal column

5: Vertical column

6: [not provided] Connection screw

7: Saddle - both ﬂat and round provided

8: Connection bolt for saddle

PAGE 1
420 Terry Ave Unit 1601 Seattle, WA 98101 425 405 5505 inlinedesign.us Installing Stainless Steel Wall Bracket Round for Flat and Round Tube Overview 1 These are instructions for proper installation of a Stainless Steel Wall Bracket Round for Flat and Round Tube, HBWA.
PAGE 2
1420 Terry Ave Unit 1601 Seattle, WA 98101 425 405 5505 inlinedesign.us Instructions 1) Begin with the wall flange and wall bracket screw/hanger bolt; thread the fine M8 threads into the flat side of the flange until finger tight 2) Using a stud-finder, locate a stud and spot drill using a 3/16” drill bit (this is true for wood or steel/metal stud).
PAGE 3
1420 Terry Ave Unit 1601 Seattle, WA 98101 425 405 5505 inlinedesign.us 4) Back out 1-2 threads of the pointed hex screw using a 2.5mm allen wrench near the round hole, and position the vertical assembly at the desired height. Secure with 2.5mm allen wrench. 5) Back out 1-2 threads of the pointed hex screw on the underside of the main assembly with a 2.5mm allen wrench. Slide the main assembly onto the mounted wall flange and position at the desired orientation before tightening the screw again.