Installation Guide


1420 Terry Ave Unit 1601
Seattle, WA 98101
425 405 5505
inlinedesign.us
Part 1: Install the Wall Bracket
1)
Using a stud-finder, locate a stud and spot drill using 3/16” drill bit (this is true for wood or steel/metal
stud)
2)
Loosen the 2.5mm hex screw enough on the underside of the main assembly to clear a few threads; this
will release the wall flange
3)
Place the wall flange over the machine threaded end of the wall bracket screw and use fingers to tighten
the screw
4)
Drive the assembled screw and flange into the hole and secure the lag end of the stud using a 13mm
wrench
5)
Position the main assembly onto the mounted wall flange at the desired orientation and tighten the small
hex screw with a 2.5mm wrench. Note: This bracket only tightens when fastened to the wall
© CableRailing.com
Page of 2 3