Installation Guide



1420 Terry Ave Unit 1601

Seattle, WA 98101

425 405 5505

inlinedesign.us

Instructions

Using a stud-ﬁnder, locate a stud and spot drill using 1/8” drill bit (true for wood or steel/metal stud)

Lift and tape ﬂange base cover to expose the 1/4” screws on wall ﬂange

Position bracket at desired orientation; use selected wall mounting screws to secure the bracket to the

mounting surface

Refer to these instructions to install Inline Design square or round tubing and additional hardware

Note: If using a round handrail, position the round saddle adapter on top of the ﬂat saddle before

attaching handrails.

NOTE: A small amount of surface corrosion is not uncommon after some exposure to weather or

salty conditions; we recommend using our passivation solution or a stainless steel polish to

prevent surface corrosion; more information available on our Engineering Specs Page

Page of 2 2