Use and Care Manual

3. Gently pull the starter handle until you feel resistance, and then pull it in the direction indicated

by the arrow in the following figure.

WARNINGS:

When you pull the starter handle, make sure not to pull it at too severe of an angle, or else you

will wear down the handle housing.

Do not allow the starter handle to rebound and retract automatically to avoid damage to the shell.

Always put the starter handle back slowly.

4. Turn the engine switch to the running position while the engine is running.

WARNINGS:

If the engine fails to start after being shut down, check the position of the tank cover switch, the

engine switch (three-in-one switch), and ensure you followed all the steps to starting the engine

properly. If you did follow steps correctly and all switches are in the ON position, check the oil level.

USING YOUR INVERTER GENERATOR

WARNINGS:

Make sure to properly ground the generator in order to prevent electric shock.