Use and Care Manual

make sure to run the generator for at least 20 hours at 50% load, which optimizes the engine
performance.
WARNING:
Before connecting your device to the AC output socket, make sure that your electrical equipment
is functioning properly. If, during use, the electrical equipment suddenly stops working or isn’t
working properly, immediately disconnect the equipment and stop the engine.
Understanding the Indicator Lights
Under normal operating conditions, the green operating indicator light will be lit.
If the generator is overloaded, or if the connected electrical equipment short-circuits, the green
operating indicator light will turn off and the red error indicator will be lit. The output power will be cut
off at this time, but the engine will still be running.
If the red error indicator lights are lit, you should first disconnect any electrical equipment. If the red error
light turns off and the green operating light comes back on, you can reconnect the electrical equipment.
If the green light does not come back on, shut down the engine and check it for any malfunctions.
Low Oil Alarm
The low oil level alarm system is designed to prevent engine damage, which can occur due to
insufficient oil in the crankcase. The low oil alarm automatically shuts down the engine before the
engine oil in the crankshaft box dips below a safe level. The generator engine switch will remain in the
ON position, but the engine itself will shut off.
Once the low oil alarm shuts down the engine, if you try to start the engine again, the yellow low oil
alarm indicator light will turn on, and the engine will not run. You will need to fill the oil before the
engine can run again.
STOPPING THE ENGINE
In an emergency, if you need to stop the engine, just turn the engine switch to the OFF position.
13