Instructions / Assembly

90045-T-CF Wicker Glass Top Table
1. Place tabletop upside down on a soft flat surface.
2. Protect glass from tools and from parts falling on glass during assembly.
3. Do not tighten bolts until entire table is completely assembled.
4. Using hex head bolts and washers attach the four table legs to the tabletop. Do not tighten bolts.
5. Using carriage bolts, washers, lock washers, nuts and caps attach the ring to the table legs. Do not tighten nuts.
6. When table is completely assembled, tighten all hardware. Do not over tighten as damage may occur.
Oxidation of iron: The iron component of the product is finished with a powder coating process that protects the iron from rusting. However, due
to the nature of the iron, rusting is inevitable. It is recommended that the consumer touch up any surface that is scratched or damaged due to wear
and tear. Applying an epoxy clear coating is recommended once a year.
For any issues with assembly please e-mail customer service at [e-mail], or call 866-656-8666
LIMITED MANUFACTURERS WARRANTY - All products produced and distributed by Oakland Living Corporation are warranted against material defects for a period of
one (1) year from the date of purchase. Any defective part will be repaired or replaced free of charge to the consumer. Cast aluminum and iron components as well
as wooden slats are warranted against breakage or structural failure during normal use of the product. Products that contain glass and or other fragile components
are not covered after delivery. Commercial use of the product voids this warranty. "Acts of God", abuse, neglect or lack of reasonable maintenance of the product is
not covered under this warranty. Damage incurred during shipment is the responsibility of the carrier. Please inspect product at time of delivery to ensure no
damage is present. Steel and iron products will eventually rust when exposed to the elements. We recommend the products be covered to protect them when not in
use, especially when not in use for extended periods of time. To preserve the beauty and finish of our tubular iron products, we recommend applying an epoxy clear
coat yearly to prevent oxidation.