Use and Care Manual

Working Time: About 1 Hour
Speed at Mode 1: 2100rpm
Speed at Mode 2: 2300rpm
Speed at Mode 3: 2500rpm
Speed at Mode 4: 2700rpm
Speed at Mode 5: 2900rpm
Speed at Mode 6: 3100rpm
Static State Current (Max.): 30uA
Working Current: (Max.): 4000mA
Static State Power (Max): 0.22mW
Voltage: 12V 2000mAH
Rated Power: 20W
Rated time: 15 minutes
FCC Instructions
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the product.
NOTE: This product has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This product generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If the product
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the product and receiver.
- Connect the product into an outlet on a circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.