Instructions / Assembly

COUNTER HEIGHT &

HIGH DINING TABLE

INSTRUCTIONS

STEP 1. Insert Spreader Bars and pole support plate in place and use

(16) 2” screws to attach to leg assemblies.

ASSEMBLY

(4) NUTS

(4) FLAT WASHER

HARDWARE PACK

• TABLETOP

• TWO LEG ASSEMBLIES

• POLE SUPPORT PLATE

• FOUR SPREADERS

STAND PARTS

• ADJUSTABLE WRENCH (not included)

• STANDARD SCREW DRIVER (not included)

• DRILL (not included)

• ALLEN WRENCH (included)

• SQUARE HEAD DRILL BIT (included)

SUGGESTED TOOLS

(16) 2” FLATHEAD SCREWS

(4) 3” BOLTS

SPREADER BAR

POLE SUPPORT PLATE

FLATHEAD

SCREWS

PAGE 1
STAND PARTS • • • • TABLETOP TWO LEG ASSEMBLIES POLE SUPPORT PLATE FOUR SPREADERS SUGGESTED TOOLS COUNTER HEIGHT & HIGH DINING TABLE I N ST R U C T I O N S • • • • • ADJUSTABLE WRENCH (not included) STANDARD SCREW DRIVER (not included) DRILL (not included) ALLEN WRENCH (included) SQUARE HEAD DRILL BIT (included) HARDWARE PACK (4) 3” BOLTS (16) 2” FLATHEAD SCREWS (4) NUTS (4) FLAT WASHER ASSEMBLY STEP 1.
PAGE 2
ASSEMBLY STEP 2. Align holes in Table Legs with holes in Table Top and use (4) 2” bolts, (4) washers and (4) lock nuts to attach leg structure to table top. Secure bolt by placing one washer, one lock washer and one nut in that order. Tighten all bolts. NOTE: Do not tighten anything until all bolts are installed. Congratulations on purchasing this Durawood 46” or 72” Dining Table. QUESTIONS REGARDING THIS PRODUCT? Call our customer service team, 800.643.3522.