Use and Care Manual

www.kegco.com
5
1-888-980-4810
Installation Instructions
BEFORE USE:
• Remove the exterior and interior packaging.
• Before connecting the unit to the power source, let it stand upright for approximately 24 hours. This will reduce
the possibility of a malfunction in the cooling system from handling during transportation.
• Clean the interior surface with lukewarm water using a soft cloth.
• This appliance is designed for freestanding use. A space of at least 3” should be allowed between the
surrounding walls and the cabinet wall for air circulation.
• Place the unit on a flat, solid floor that is strong enough to support it when it is fully loaded.
• If the refrigerator is to be placed on carpet, support it with a wooden board underneath. Be aware that placin
g
t
he refrigerator on carpet may mean that heat from the compressor may cause the carpet to fade.
• When moving your refrigerator, please do not incline it more than 45 degrees.
• Locate the appliance away from direct sunlight and sources of heat (stove, heater, radiator, etc.). Direct sunlight
may affect the acrylic coating and heat sources may increase electrical consumption.
• The refrigerator should be placed in an area where the ambient temperature is less than 90 degrees Fahrenheit
and higher than the lowest temperature you want to store your beverages at. If the ambient temperature is
lower than the set temperature, the internal temperature will match the ambient temperature.
• Install the unit in a dry place to prevent rust from forming on the compartment body, which may affect the
electrical insulation.
• Plug the cooler into an exclusive, properly installed and grounded wall outlet. Do not under any circumstances
cut or remove the third (ground) prong from the power cord. Any questions concerning power and/or electrical
g
rounding should be directed to a certified electrician or authorized products service center.
• After plugging the appliance into a wall outlet, allow the unit to cool down for 3 to 4 hours before stocking it
with beverages.
INSTALLING THE DISPENSE SYSTEM:
1. Plug in unit and pump.
2. Insert full keg and let cool to 38°F
3. Attach faucet to shank in door.
4. Attach ball lock liquid connector to
“out” post on keg.
5. Attach ball lock air vent to
“in” post on keg.
6. Turn pump switch on.