Use and Care Manual

www.kegco.com
8
1-888-980-4810
Care and Maintenance
Disconnect the appliance from the power source before cleaning. When you have finished cleaning, reconnect the plug
with dry hands.
INTE
RNAL CLEANING OF THE CABINET:
• Do not pour water over the appliance.
• The cooler interior should be cleaned periodically using a solution of baking soda and lukewarm water (5 ml to
0.5 liter of water).
• Do not use abrasive products, detergents, or soaps.
• After washing, rinse with clean water and dry carefully.
EXTER
NAL CLEANING OF THE CABINET:
• Wash the outer cabinet with warm soapy water. Do not use abrasive products.
• There are sharp edges on the underside of the product, so care should be taken when cleaning.
• Once or twice a year, dust the back of the appliance with a brush or vacuum cleaner, as an accumulation of dust
will affect the performance of the appliance and cause increased energy consumption.
WAR
NING:
1. Never clean the unit with an abrasive, acid, oil, or solvent based cleaning agent, or with abrasive pads or
scourers. Never use flammable fluids or sprays for cleaning as the fumes from these substances can create a fire
hazard or explosion.
2. Never clean the appliance with a steam cleaner. Moisture could accumulate in the electrical components,
creating the risk of an electric shock. Hot vapors can lead to damage to the plastic parts.
3. The appliance must be completely dry before it is placed back into service.
4. Ethereal oils and organic solvents (like lemon juice, orange peel juice, or cleansers that contain acetic acid) can
attack plastic parts. Do not allow such substances to come into contact with the appliance parts.
CLEANING THE DISPENSE SYSTEM
1. Mix 15ml (7.5ml per gallon or 2ml per liter) of keg cleaner with 8 liters of water in the empty keg.
2. Soak for up to 15 minutes.
3. Flush the solution through the line.
4. Flush the line twice with clean water.
5. Complete sanitizing step using keg cleaner.
SANITIZING THE DISPENSE SYSTEM
1. After the keg has been cleaned, fill t
he keg first with 8 liters of water, then add 15ml (7.5ml per gallon or 2ml per
liter) of kegerator line cleaner and mix.
2. Allow the solution to remain in the keg for at least 1 minute.
3. Flush the solution through the line.
4. Do not rinse for 10 minutes but rinse before next use.
DEFROSTING:
The surface of the evaporator ices up when the refrigerator is working. This is an entirely normal part of operation. If
the frost layer is more than 1/8” thick, the refrigerator must be defrosted and cleaned to avoid unnecessary energy
consumption and inefficient operation.
• Remove all items inside and unplug the refrigerator.
• After defrosting, clean the refrigerator and allow it to dry.
• Reconnect to the power supply and run the refrigerator.