PuraFlame Western Electric Fireplace Insert Model Number: (EF42D, EF43D, EF44D, EF45D, EF302A) OWNER'S MANUAL WARNING Read and understand this en re owner's manual, including all safety informa on, before plugging in or using this product. Failure to do so could result in fire, electric shock, or serious personal injury. CAUTION Keep this owner's manual for future reference. If you sell or give this product away, make sure this manual accompanies this product.
1. Important Safety Information .............................................................1 2. Technical Specifications .....................................................................4 3. 1) Electric Specifications .................................................................4 2) Product Specifications ................................................................4 Before Installation .............................................................................5 1) Check ...........
1. IMPORTANT SAFETY INFORMATION WARNING Ÿ Read all instruc ons before using this heater! Ÿ This heater is hot when in use. To avoid burns, DO NOT let bare skin touch hot surfaces. If provided, use handles when moving this heater. Keep combus ble materials, such as furniture, pillows, bedding, papers, clothes, and curtains at least 3 feet (0.9m) from the front of the heater, and keep them away from the sides and rear.
(outlet/power strip). Ÿ Connect to properly grounded outlets ONLY. Ÿ DO NOT place the heater near a bed because objects such as pillows or blankets can fall off the bed and be ignited by the heater. Ÿ NEVER use this heater in bathrooms, laundry rooms, or any other loca on where the heater could fall into a bathtub or pool, become damp, or come in contact with water. Ÿ AVOID FIRE! Regularly inspect all air vents to make sure they are free from dust, lint, or other blockage.
Ÿ ALWAYS store this heater in a dry loca on. NEVER use the fireplace if it has become wet. Ÿ ONLY use this heater on a 120V AC 15-Amp circuit. NEVER overload the circuit. If this heater trips the circuit breaker, unplug all other appliances on the same circuit before the next use. Avoid plugging other appliances into the same circuit as this heater. Ÿ NEVER plug this heater into an outlet that is old, cracked, or has any loose wires or connec ons.
2. TECHNICAL SPECIFICATIONS 1) Electric Specifica ons Model Volt Wa (min/max) Hz BTU(max) Amp Hea ng Area(max) EF42-45D EF302A 120 750/1500 60 4600 12.5 400 square feet 2) Product Dimensions B C D Power Cord Removable Handle G H E F A Units: inches Model A B C D E F G H EF42D 24.80 22.91 21.89 16.93 21.46 20.04 8.7 7.8 EF43D 27.95 25.96 25.20 20.02 24.61 23.19 8.7 7.8 EF44D 31.89 29.90 29.02 23.95 24.61 23.19 8.7 7.8 EF45D 35.04 33.05 32.29 27.10 26.
3. BEFORE INSTALLATION 1) Check: WARNING! DO NOT use this Electric Fireplace if any part has been under water. Immediately call a qualified service technician to inspect and to replace any part of the electrical system if necessary. Keep plas c wrapping away from children. Spare Parts Checking Open the packaging carefully and remove the polystyrene. Ÿ Check all the spare parts are fully received. Ÿ Carefully check if any damages that may have for the spare parts.
4. INSTALLATION INSTRUCTIONS ALWAYS unplug this fireplace heater before assembly or cleaning, or before reloca ng. Failure to do so could result in electric shock, fire, or personal injury. KEEP drapery and other furnishings at least 3 the front and sides of the electric fireplace. /0.9m from AFTER installa on, ensure that there is ≥0.004㎡ ven la on area between inside and outside of fireplace mantel. 1) Loca ng the Appliance Your new electric fireplace may be installed virtually anywhere in your home.
3) Recessed into a wall It is available to install the unit into a wall. The opening depth 8.1” is suggested for be er ven la on. Build the opening according to the suggested specifica on shown below. Opening sizes ranges/inches SKU Width Height EF42D 21.9-23.9 20.1-21.3 EF43D 25.2-27.2 23.2-24.4 EF44D 29.1-31.1 23.2-24.4 EF45D 32.3-34.3 25.6-26.6 EF302A 32.3-34.3 21-22 Depth(min) Depth(suggest) 7.8 8.
4) Insert into a cabinet or wood mantel. It is available to install the unit into a wood cabinet or mantel. Also, it would be be er to keep the depth at 8.1”. The clearance from the top of the unit to the bo om of TV or something else si ng on the cabinet should be 8” at least. When moving the insert into a mantel, DO NOT let bo om of insert touch the mantel to avoid scratches. 5.
5a. Manual Control Panel ON/OFF Flame(3 settings) Heater(750/1500w) Thermostat Note: When the heater is first turned on, a slight odor may be present. This is normal and should not occur again unless the heater is not used for a long period of me. BUTTON NAME FUNCTION POWER SWITCH Turn the main power switch on. A long “beep” sound will be heard when the switch is turned at ON Posi on “I”. Note: The remote control will lost the memory for func on se ngs when the switch is turned at OFF Posi on “O”.
FLAME The flame will be cycled from Flame A – Flame B – Flame C – Flame Off. Flame A: full bright flame + li le blue Flame B: full bright flame Flame C: half bright flame HEATER The heater will be cycled from Low – High – Heater Off. The indicator light on le to Power Switch (see the second picture on last page) will illuminate when the heater is turned on. The indicator light will go out within 10s. Low: (●○) High: (●●) Note: 1. Heater can be used without flame. 2.
5b. Remote Control Note: Remote control can be used only when the main power switch is on. Aim the remote control at the remote receiver (see picture on page 9) which is on the le of the main power switch POWER CRACKLING LOW HIGH NOTE: A coin cell (CR2032) should be used for this remote but it is NOT included in the package in considera on of the transporta on safety, please source it locally. BUTTON POWER TITLE FUNCTION POWER The power bu on will put the unit in standby mode.
FLAME The flame will be cycled from Flame A – Flame B – Flame C – Flame Off. LOW HEAT To turn on the heater on half heat se ng or turn off the heater. HIGH HEAT To turn on the heater on full heat se ng or turn off the heater. CRACKLING To turn on the crackling and cycle through high crackling sound – normal crackling sound – low cracking sound - high crackling with wind sound – normal crackling with wind sound – low crackling with wind sound- off.
6. CARE AND MAINTENANCE ALWAYS turn the heater OFF and unplug the power cord from the outlet before cleaning, performing maintenance, or moving this fireplace. Failure to do so could result in electric shock, fire, or personal injury. Cleaning NEVER immerse in water or spray with water. Doing so could result in electric shock, fire, or personal injury. Metal: Buff using a so cloth, slightly dampened with a citrus oil-based product.
Maintenance Risk of electric shock! DO NOT OPEN! No userserviceable parts inside! ALWAYS turn the heater OFF and unplug the power cord from the outlet before cleaning, performing maintenance, or moving this fireplace. Failure to do so could result in electric shock, fire, or personal injury. Electrical and Moving Parts: Ÿ The fan motors are lubricated at the factory and will not require lubrica on. Ÿ Electrical components are integrated in the fireplace and are not serviceable by the consumer.
transport from the point of purchase to the consumer's home. This warranty does not cover glass, light bulbs, ba eries, transporta on, labor, or other issues not associated with the manufacture of the product. This product is for residen al use only. Any and all commercial use of this product voids all warran es, and frees the manufacturer from all liability. Read and understand all assembly and opera ng instruc ons, and all safety informa on and warnings, before use.
2) If the power cord is fine, check the wires behind the rocker switch to see if they are burned. 3) If the wires are well, too, the PCB board might be broken and need to be replaced. Please contact service team for a replacement and instruc on. 3. The heater does not work, it turns on for several seconds then shuts off itself. 1) New product: a. Turn the thermostat to 8 to see if the heater will work con nuously. b. If not, unplug the unit for a whole night. c.
for help. 6. The flame does not show up or flicker or a noise when turn it on. Please contact service team for a checking instruc on of the flame LED board connecter, flame motor and spindle. 7. There is a black e inside the unit or there is a small spot on the glass. Please contact service team for an instruc on of removing the glass. 8. The front trim is out of shape, the remote is missed or the log is broken. Please contact service team for a replacement and instruc on. 9.
Ningbo Richen Electrical Appliance Co., Ltd Address: No.19, Yongdinghe Road, Xiapu, Beilun, Ningbo PR. China www.puraflame.com 3.EF.43.05.
