Use and Care Manual
10
The flame will be cycled from Flame A –
Flame B – Flame C – Flame Off.
Flame A: full bright flame + lile blue
Flame B: full bright flame
Flame C: half bright flame
The heater will be cycled from Low – High –
Heater Off. The indicator light on le to
Power Switch (see the second picture on
last page) will illuminate when the heater is
turned on. The indicator light will go out
within 10s.
Low: (●○)
High: (●●)
Note:
1. Heater can be used without flame.
2 . T h e h e a t e r w i l l w o r k w h e n t h e
temperature set by thermostat is higher
than room temperature.
3. The Fan works about 10s ahead of the
heater, and stops about 10s later than the
heater.
4. The indicator light in the lower fuel bed
(see the first picture on last page) always
illuminates when heater is on.
Turn it to seng 9 first and when the room
has reached a desired level, turn the rotary
switch counterclockwise slowly unl the
thermostat just 'clicks' off. The thermostat
will then maintain the room at this selected
level. To increase the temperature, turn the
rotary switch clockwise to a higher seng.
FLAME
HEATER
THERMOSTAT