Use and Care Manual
12
CRACKLING
HIGH
LOW
The flame will be cycled from Flame A – Flame B
– Flame C – Flame Off.
To turn on the heater on half heat seng or
turn off the heater.
To turn on the heater on full heat seng or turn
off the heater.
To turn on the crackling and cycle through high
crackling sound – normal crackling sound – low
cracking sound - high crackling with wind sound
– normal crackling with wind sound – low
crackling with wind sound- off.
Temperature Liming Control
This heater is equipped with a Temperature Liming Control. Should
the heater reach an unsafe temperature, the heater will automacally
turn OFF. To reset:
Ÿ Unplug the power cord from the outlet.
Ÿ Turn the Power Switch on the CONTROL PANEL to OFF. Wait at least
5 minutes.
Ÿ Inspect the fireplace to make sure no vents are blocked, or clogged
with dust or lint. If they are, use a vacuum to clean the vent areas.
Ÿ With the Power Switch in the OFF posion, plug the power cord
back into the outlet.
If it switches off again, UNPLUG THE HEATER RIGHT AWAY! Have the
outlets, wiring, and breaker box inspected by a professional. Make
necessary repairs before using the heater.
LOW HEAT
FLAME
HIGH HEAT
CRACKLING