Use and Care Manual

3
Ÿ ALWAYS store this heater in a dry locaon. NEVER use the fireplace
if it has become wet.
Ÿ ONLY use this heater on a 120V AC 15-Amp circuit. NEVER overload
the circuit. If this heater trips the circuit breaker, unplug all other
appliances on the same circuit before the next use. Avoid plugging
other appliances into the same circuit as this heater.
Ÿ NEVER plug this heater into an outlet that is old, cracked, or has any
loose wires or connecons. Plugging this heater into a faulty
outlet could result in electric arcing within the outlet that could
cause the outlet to overheat or catch fire.
Ÿ ALWAYS check your heater cord and plug connecons with each use!
1. MAKE SURE the plug fits ght in the outlet! Faulty wall outlet
connecons or loose plugs can cause the outlet to overheat.
2. Heaters draw more current than small appliances. Overheang
may occur even if it has not occurred with the use of other
appliances.
3. During use check frequently to see if the plug outlet or faceplate
is HOT!
4. If the outlet or faceplate is HOT, disconnue use immediately and
have a qualified electrician inspect and/or replace the faulty
outlets.
This heater has a polarized plug
(on e bl a d e is wider tha n t h e
other). As a safety feature to
reduce the risk of electrical shock,
this plug is intended to fit in a
polarized outlet only one way. If
the plug does not fit fully in the
outlet, reverse the plug. If it sll
does not fit, contact a qualified
electrician. Do not aempt to
defeat this safety feature.
SAVE THESE INSTRUCTIONS!