Use and Care Manual
6
ALWAYS unplug this fireplace heater before assembly or
cleaning, or before relocang. Failure to do so could result in
electric shock, fire, or personal injury.
KEEP drapery and other furnishings at least 3 /0.9m from
the front and sides of the electric fireplace.
AFTER installaon, ensure that there is ≥0.004㎡ venlaon
area between inside and outside of fireplace mantel.
1) Locang the Appliance
Your new electric fireplace may be installed virtually anywhere in
your home. However, when choosing a locaon, ensure that the
general instrucons for safety are followed.
Ÿ For best results, install out of direct sunlight, water or very
damp air.
Ÿ Power supply service must be installed within proximity of
electric fireplace prior to finishing avoiding reconstrucon.
2) Locate an outlet
Ÿ Plug in (you may run the power cord out of the framed wall
opening to an exisng outlet or install an outlet on a nearby wall
stud within the wall). The circuit should be 120v 15amp.
Ÿ The power cord is 6 long. If the cord is not long enough to
reach the outlet, a grounded extension cord minimum AWG No.
14 wiring and rated to a minimum or 1875 was may be used,
please kindly noted that it should not be longer than 7.87.
Ÿ Make sure the outlet is in good condion and that the plug is not
loose. NEVER exceed the maximum amperage for the circuit. DO
NOT plug other appliances into the same circuit.
4. INSTALLATION INSTRUCTIONS