Specification

Vantage
®
300 | [ 3 ]
FEATURES
Single-side engine access
with lockable sliding door.
Fuel, oil pressure and engine
temperature gauges help you
monitor performance.
Latched and lockable
radiator cap cover.
Convenient battery tray below
control panel.
Handy oil drain valve and tube
makes oil changes neat.
Output automatically switches to
remote mode when remote device is
connected. For the CC-stick,
downhill pipe and Touch Start TIG
®
modes, the machine output dial
becomes a maximum current limit
for more fine tuning with the remote
control dial or Amptrol
™
.
1. Glow Plug Button
2. Weld Mode Selector Switch
3. Run/Stop Switch
4. Hour Meter
5. Start Pushbutton
6. Engine Idler Switch
7. Fuel Level, Engine Temperature and
Oil Pressure Gauges
8. Engine Protection Light
9. Engine Battery Charging Light
10. 120 VAC Circuit Breakers
11. 120 VAC Receptacles
12. Covered Weld Output Terminals + and -
13. Sealed GFCI Modules
14. Ground Stud
15. 120/240 VAC Full-KVA 1-Phase Receptacle
16. 240 VAC Full-KVA 3-Phase Receptacle
17. Full-KVA 1- & 3-Phase Circuit Breaker
18. 14-Pin Wire Feeder Connector
19. 6-Pin Remote Control Connector
20. Arc Force & Inductance/Pinch Control Dial
21. Welding Terminals Control Switch
22. Wire Feeder Voltmeter Polarity Switch
23. Digital Amps and Volts Output Meters
24. VRD
™
Indicator Lights
25. Output Control Dial
Note: Control panel door not shown.
1
2
11
25
24
23
22
21
20
19
17
16
15
18
10
9
8
7
6
5
4
3
12
13
• Simple Controls – Keeps training time to a minimum. The flip-down
control panel door keeps less frequently used dials out of the way.
Scratch-resistant Lexan
®
nameplate.
• Digital meters for amps and volts output make it easy to
precisely set your procedures.
• Large 20 gallon (76 liter) fuel tank provides run time for an extended
day – over 16 hours of welding at 300A/32V/100% duty cycle output, or
49 hours at high idle.
• The Kubota
®
V1505 engine is a 22 horsepower, water-cooled, 4
cylinder diesel engine with an automatic idler for greater fuel economy
and reduced noise.
• Engine hour meter makes it easy to schedule maintenance.
• LN-25 Ironworker
™
arcoss-the-arc wire feeder is a recommended
option.
• 14-pin connector for Lincoln Electric wire feeders with control cables:
LF-72, LF-74, LN-8, Activ8
™
, LN-25 PRO Dual Power, and LN-742. Also
compatible with Magnum
®
SG spool gun system.
• Two Vantage
®
300 units can be paralleled in the CC-stick mode to
increase output.
• Kilowatts available for Multi-Weld
®
350 use: 4.8 KW @ 60 VDC,
7.0 KW @ 58 VDC.
KEY CONTROLS
14