Instructions / Assembly

ManualsBrandsUnbranded ManualsBarn DoorsBastille 37 in. x 84 in. 3/4 Lite Frosted Glass Black Metal Finish Sliding Barn Door with Hardware Kit

colonialelegance inc.

HOW TO INSTALL YOUR RAIL

METRO COLLECTION - MURAL DOOR SYSTEM

Parts includedDoor included Recommended tools

1. Mounting the rail

From the ﬂoor, add 1 3/4” to the height of the door being installed,

to determine the center height of the rail.

Ex: Door 84”

+ 1 3/4” = 85 3/4” center of the rail from the ﬂoor.

CAUTION if the rail is not installed level, the door may slide open

or closed without warning.

Mark the location for each lag screw.

IMPORTANT - PLEASE READ ALL INSTRUCTIONS BEFORE YOU BEGIN INSTALLATION.

• These instructions are for a single door installation.

• Identify secure points on the wall to attach the rail before starting your installation.

• It is necessary that all the lag screws used to install the rail are secured to the wall stud (2 x 3 structure).

• Use a wood plank secured to the wall stud if you are unable to fix all lag screws in wall stud.

1/2” & 5/8”

7/32”

DOOR HEIGHT

+ 1 3/4”

1.1 1.2

RAIL (1X)

STOPPER

SBSTPR (2X)

ANTI-JUMP

BUMPER

SBGDAJ (2x)

DOOR GUIDES

BOLT KIT

SBR-BOLT

(4 BOLTS)

SPACER

LAG SCREW KIT

SBKS5 (5x)

ROULETTE

(2X)

Summary of content (6 pages)

PAGE 1
HOW TO INSTALL YOUR RAIL METRO COLLECTION - MURAL DOOR SYSTEM IMPORTANT - PLEASE READ ALL INSTRUCTIONS BEFORE YOU BEGIN INSTALLATION. • • • • These instructions are for a single door installation. Identify secure points on the wall to attach the rail before starting your installation. It is necessary that all the lag screws used to install the rail are secured to the wall stud (2 x 3 structure). Use a wood plank secured to the wall stud if you are unable to fix all lag screws in wall stud.
PAGE 2
#4 #2 #1 #3 1.3 Drill 7/32” pilot holes at each mark. 1.4 Place one lag screw through the middle hole #1 through a spacer. Do not fully thighten. Repeat process with holes #2 and #3. Use a level on top of the rail to ensure it is properly levelled, then thighten the 3 lag screws. NOTE Lag screws #4 and #5 will be installed later. 2. Installing Door Hangers 2.1 Make sure to align the trolley and the screws with the holes. #5 2.2 Secure the trolley by tightening both screws.
PAGE 3
. Complete your Installation TOP VIEW TOP VIEW 3.1 3.2 NOTE Anti-jump bumpers must be installed to prevent door from derailing. Loosely fasten the anti-jump bumpers in the hole next to the trolley. To be able to install the door on rail, anti-jump bumpers must be turned towards the front of the door. Hang the door on the rail, ensure the door is levelled then, fix the door guides on the floor on the opening side, as close to the doorway as possible. 3.
PAGE 4
COMMENT INSTALLER VOTRE RAIL COLLECTION METRO - SYSTÈME DE PORTE MURALE IMPORTANT - VEUILLEZ LIRE LES INSTRUCTIONS AVANT DE COMMENCER L’INSTALLATION. • Il s’agit d’instructions pour l’installation d’une porte simple. • Avant de débuter, déterminer l’emplacement des trous de façon à assurer un ancrage solide au mur. • Tous les tire-fonds utilisés pour l’installation doivent être fixés dans les montants du mur (structure en 2 x 3).
PAGE 5
#4 #2 #1 #3 #5 1.3 Pré-percer chaque marque à l’aide d’une mèche de 7/32”. 1.4 Placer un espaceur derrière le trou #1 et y insérer un tire-fond. Ne pas serrer complètement. Répéter le processus pour les trous #2 et #3. Utiliser un niveau au-dessus du rail pour s’assurer qu’il est de niveau, puis serrer complètement les 3 tire-fonds. NOTE Les tire-fonds #4 et #5 seront installés plus tard. 2. Installation des roulettes 2.1 Aligner les roulettes et les vis avec les trous filetés. 2.
PAGE 6
3. Mise en place DESSUS DESSUS 3.1 3.2 NOTE Les rondelles anti-déraillement doivent être installées pour empêcher la porte de dérailler. Sans serrer, fixer les rondelles anti-déraillement dans les trous prévus à cette effet. Pour pouvoir installer la porte sur le rail, les rondelles anti-déraillement doivent être tournées vers le devant de la porte. Monter la porte sur le rail, en s’assurant qu’elle est de niveau, puis fixer les guides de porte au sol, le plus près possible de l’ouverture. 3.4 3.