® LEER, INC. 206 Leer Street, P.O. Box 206 New Lisbon, WI 53950 1-800-766-5337 MERCHANDISER INSTALLATION, OPERATION, SAFETY AND MAINTENANCE MANUAL Q.B.
ITEM DESCRIPTION PAGE I. PACKAGING ........................................................................................................................ 3 II. INSTALLATION ................................................................................................................... 3 III. OPERATION ......................................................................................................................... 1. Electrical ..........................................................
I.I.PACKAGING PACKAGING III. III.OPERATION OPERATION All merchandisers are run cycle tested, inspected and carefully packaged to ensure each unit arrives ready for operation. Retain this manual for future reference and required maintenance. 1. Electrical: The electrical voltage and frequency cycle at installation site must coincide with merchandiser decal label. Electrical service connections must be in accordance with the national electrical code and any local code that may apply.
III. OPERATION CONT. IV. MAINTENANCE 1. NOTE: Some models are equipped with a main power switch. If so equipped, make sure the switch CAUTION: Disconnect power plug from ! electrical is in the off position before plugging the supply before maintenance on merchandiser into the outlet. Plug the merchandiser electrical components to avoid risk of power cord into the lower receptacle of electrical electrical shock. outlet. After a few seconds delay, the compressor and the condenser fan motor should start.
IV. MAINTENANCE CONT. B. Hinges exposed to harsh environmental conditions may require a lubricant for ease of operation. Spray a light penetrating oil on hinge pivot points to ease the work load and extend life of hinge. C. Condensate Evaporator: Inspect operation and condition of evaporator every three (3) months. The heating rod should be heating and examined for excessive corrosion. Failure of the heating rod to heat properly can result in the drain pan water overflowing.
V. ELECTRONIC CONTROL ELECTRONIC CONTROL DEFROST ICON – MELTING SNOWFLAKE REFRIGERATION ICON - SNOWFLAKE MANUAL DEFROST BUTTON SET BUTTON TEMPERATURE DISPLAY To see the set point – Press and release the SET key. The control set point will be displayed. To initiate a manual defrost – Press the defrost key for more than 2 seconds and a defrost will begin. NOTE: The cabinet temperature must be below 40 degrees for this function to operate.
VI. COLDWALL WIRING DIAGRAM VII.
VIII.
IX.
X. REPLACEMENT PARTS ITEM DESCRIPTION 1. Condensing Unit: Provide condensing unit model number 2. 3.
ICE MERCHANDISERS: Seller warrants the merchandiser under normal use and service, for one (1) year for component parts (to be shipped by seller), and ninety (90) days for repair labor from the date of original shipment. The merchandiser compressor motor is warranted for five (5) years from the date of original shipment. SELLER MUST BE CONTACTED AND PROVIDED A MERCHANDISER SERIAL NUMBER FOR WARRANTY CLAIM. This warranty applies only to goods installed in the United States.
