Installation Guide

ENGLISH

FAUCET INSTALLATION

Thank you for purchasing this Pster product. All Pster products are carefully

engineered, and factory tested to provide long trouble-free use under normal conditions.

This product is easy to install using basic tools and our easy to follow illustrated

instructions. If you have any questions regarding this product, call 1-800-Pfaucet

(1-800-732-8238).

1 BEFORE PROCEEDING

WARNING: Read all the instructions completely before proceeding. Pster

recommends calling a professional if you are uncertain about installing this product!

This product should be installed in accordance with all local and state plumbing and

building codes.

2 SHUT OFF WATER SUPPLY

Locate water supply inlets and shut off the water supply valves. These are usually found

under the sink or near the water meter. If you are replacing an existing faucet, remove

the old faucet from the sink and clean the sink surface thoroughly.

3 TOOLS RECOMMENDED

• Plumber’s putty • Slotted screwdriver • Pliers

• Adjustable wrench • Flashlight • Cloth

Your installation may require new supply lines and / or shut-off valves or other additional

tools.

4 FAUCET PREPARATION

Insert Lift Rod (4A) through the bottom of Faucet Body (4B) and vertically into Slot (4C)

on back of Spout (4D) as shown. Ensure that Seal Base (4E) is pressed onto Spout Base

(4F). Place Spout Base (4F) and Seal Base (4E) onto the bottom of Faucet Body (4B).

The Red and Blue Indicator (4G) can be switch with a solid colored Indicator (4H)

that is provided (See step 12).

5 FAUCET INSTALLATION

Following manufacturer’s recommendations on use, apply plumber’s putty into putty

groove in bottom of Seal Base (5A). With the handle and spout facing forward, carefully

insert Threaded Shank (5B) and Faucet Inlets (5C) through hole on sink.

For 3 hole Installation, order Deck Plate

961-095*

separately.

6 SECURING FAUCET

From underneath sink, secure Faucet Body (6A) by placing Metal Washer (6B) and

threading Long Nut (

“ Hex.) (6C) onto Threaded Shank (6D). Make sure that the

bumps on Metal Washer (6B) are facing up. Firmly hand tighten Long Nut (6C). Make

sure Lift Rod (6E) moves freely. Secure Long Nut (6C) not to exceed a quarter turn.

Caution: Do not over tighten!

BOTTOM GROOVE