Installation Guide

ENGLISH

DRAIN BODY INSTALLATION

FAUCET FUNCTIONS

MAINTENANCE & CARE

7 WATER SUPPLY CONNECTIONS

Gently separate hot and cold Supply Tubes (7A), approximately three inches apart.

Connect water Supply Lines (7C) to Faucet Inlets (7B). Hot water supply line goes to hot

inlet tting indicated by red tag (7D). (Supply lines not included). Follow manufacturer’s

instructions when installing supply lines.

Hold the Faucet Inlets (7B) steady using an adjustable wrench while tightening Supply

Lines (7C). Do not twist Supply Tubes (7A)!

8 DRAIN INSTALLATION

Install and adjust Drain (8A) using separate instructions supplied with the Drain assembly.

9 UNIT START UP

Turn on hot and cold water supplies, and check for leaks above and below the sink.

10 FAUCET FUNCTION

By lifting the Lever Handle (10A) up, the valve will be activated allowing water to ow.

The water ow will increase by continuing to lift up the Lever Handle (10A). By rotating

the Lever Handle counter-clockwise, the water temperature will decrease to cold ow

only. By rotating the Lever Handle clockwise, the water temperature will increased to

hot ow only.

11 FLUSHING & AERATOR CLEANING

After installation is complete, remove Aerator Housing (11A). Turn Valves (11B) on

and allow both hot and cold water to run for at least one minute each. While water is

running, check for leaks. To clean the aerator, disassemble Aerator Housing (11A) by

separating the Aerator Shell (11C), Basket (11D), and Washer (11E). Once parts have

been cleaned, reassemble by reversing steps.

10A

11A

11B

11E

11D

11C

HOT

COLD

OPEN

HOT

COLD