Datasheet

Linear/Slide Potentiometer Module

Introduction

The slide potentiometer is a linear variable resistor with a total resistance of 10k. When you

move the lever from one side to the other, its output voltage will range from 0 V to the VCC

you apply. It has four pins, 3 of which are connected to VCC, GND and the ADC IN on the

slide, while the remaining pin is connected to a red indicator LED. You can use the indicator

LED to visually display the change on the potentiometer.

PAGE 1
Linear/Slide Potentiometer Module Introduction The slide potentiometer is a linear variable resistor with a total resistance of 10k. When you move the lever from one side to the other, its output voltage will range from 0 V to the VCC you apply. It has four pins, 3 of which are connected to VCC, GND and the ADC IN on the slide, while the remaining pin is connected to a red indicator LED. You can use the indicator LED to visually display the change on the potentiometer.
PAGE 2
Application Ideas int adcPin = A0; int ledPin = A1; int adcIn = 0; // select the input pin for the potentiometer // select the pin for the LED // variable to store the value coming from the sensor void setup() { Serial.begin(9600); // init serial to 9600b/s pinMode(ledPin, OUTPUT); // set ledPin to OUTPUT Serial.
PAGE 3