Datasheet

TILT Sensor

Introduction

The Linker Tilt Module is the equivalent of a button, and is used as a digital input. Inside the

tilt switch is a pair of balls that make contact with the pins when the case is upright. Tilt the

case over and the balls don't touch, thus not making a connection. It is wired to the SIG line,

NC is not used on this kit.

PAGE 1
TILT Sensor Introduction The Linker Tilt Module is the equivalent of a button, and is used as a digital input. Inside the tilt switch is a pair of balls that make contact with the pins when the case is upright. Tilt the case over and the balls don't touch, thus not making a connection. It is wired to the SIG line, NC is not used on this kit.
PAGE 2
Application Ideas int ledPin = 13; int switchPin = 7; int val = 0; void setup() { pinMode(ledPin,OUTPUT); pinMode(switchPin,INPUT); } void loop() { //digitlRead(switchPin,HIGH) val = digitalRead(switchPin); if (HIGH == val) digitalWrite(ledPin,HIGH); else digitalWrite(ledPin,LOW);