Instructions / Assembly

Step 2: Install cylinder by placing

the Easy Mount plate on the

inside of the door and inserting

the provided 1/4" screws.

Step 3: Place the LarcenyLock housing over the

Easy Mount plate. Use a square, level, or

measuring tape to make sure the housing is level,

then insert the 4 mounting screws as shown. Be

sure the thub turn is in the unlocked position so

the cylinder tailpiece blade enters the Larceny

Lock.

Larceny Lock Installation Instructions

Step 1: Insert deadbolt

into cross bore hole as shown.

Fasten into door with supplied

screws.

Rivers Security Specialists does not make any guarantees or warranty this

product in any way. RSS will not be held repsonisble for any loss or damages

from the use of this or any RSS product.

PAGE 1
Larceny Lock Installation Instructions Step 2: Install cylinder by placing the Easy Mount plate on the inside of the door and inserting the provided 1/4" screws. Step 1: Insert deadbolt into cross bore hole as shown. Fasten into door with supplied screws. Rivers Security Specialists does not make any guarantees or warranty this product in any way. RSS will not be held repsonisble for any loss or damages from the use of this or any RSS product.
PAGE 2
Larceny Lock Installation Instructions (continued) Step 7: Check for proper operation of the door and lock. Lock should lock and unlock with out dragging on the strike plate. Make any adjustments as neccesary. Step 4: Using a straight edge, mark on the door frame where the top of the housing is. Step 5: Repeat for the hinge side of the door. Step 6: If there is not enough clearance between the door and frame, mortise the strike plates into the door frame, lining the top of the strike plate with the line.