Instructions / Assembly

E
Step 4: Using a straight edge, mark on the
door frame where the top of the housing is.
Step 5: Repeat for the hinge side of the door.
P
Step 6: If there is not enough clearance between
the door and frame, mortise the strike plates into
the door frame, lining the top of the strike plate
with the line.
Sink the 4 inch long screws using a #3 phillips bit.
The weather stripping may need to be
termporarily removed or pushed back to allow
the back screws to be sunk.
Step 7:
Check for proper operation
of the door and lock. Lock should
lock and unlock with out dragging
on the strike plate. Make any adjustments
as neccesary.
Rivers Security Specialists does not make any guarantees or warranty this
product in any way. RSS will not be held repsonisble for any loss or damages
from the use of this or any RSS product.
Larceny Lock Installation Instructions (continued)