Warranty

5
FRAMING THE BATH
For proper drainage and stability, your Signature bath must be level and the full bottom of the full bath be seated rmly on the sub-
oor. If the sub-oor requires leveling, measurements must be adjusted to include clearance for mortar between the oor and the
bottom of the bath. The rim of the bath will not support weight.
Three Wall Alcove Installation:
The interior of the alcove must be the same size
as the exterior dimension of the bath. Measure
from the oor and mark a stud at the correct
height for the ledger board. Mark each stud to
create a level line on all 3 walls of the alcove.
Align 1 x 3” ledger boards with the level line and
screw into the studs on all 3 alcove walls. Place
a level in the center of the ledger board on each
wall and in both corners to conrm the ledger
boards are level. Build a frame of the same
height to enclose the exposed side of the bath.
*Framing must include unrestricted access to the
component side of the bath.
Platform Installation:
Build a platform with an opening 2” smaller
than the outside dimension of the bath. A large
opening reduces the risk of damage to the bath
and components when the bath is lowered into
the opening *Framing must include access to all
components
INSTALLING THE HARDWARE
Following the manufacturers instructions for each, install the drain kit, faucet and ange (each purchased separately). Signature bath
recommends that a qualied plumber install all hardware.
PREPARING THE SUB- FLOOR
To assure it drains properly and the weight is evenly distributed on the bottom, your bath must be installed on a level oor. If the
Deck Covering must be added into Dimension C